Refill the regreasable sealing systems with grease

WARNING

Risk of crushing due to rotating parts.
Severe or fatal injuries.
  • Observe the 5 safety rules before commencing the work: Disconnect. Secure the device against a restart. Check that no voltage is applied. Ground and short-circuit. Cover or isolate neighboring live parts.

INFORMATION

  • Slowly turn the shaft when relubricating the bearing to ensure better distribution of the grease.
  • Refer to www.sew‑eurodrive.de/lubricants for the used lubricants.
  • Immediately remove any old grease that has leaked out.
  1. For the exact lubrication points, refer to the order-specific dimension sheet.
  2. Use moderate pressure to force grease into each lubrication point until new grease leaks out of the sealing gap.
  3. The used grease is pressed out of the sealing gap together with any contaminants it has absorbed.