Startup procedure

WARNING

No shutdown due to faulty parameter settings. If the parameters are not set correctly during startup, the fault response of the energy storage system may fail.
Severe or fatal injuries.
  • Set the parameters correctly in the MOVIKIT® PowerMode or EnergyMode software modules during the startup process in the MOVISUITE® engineering software.
  • If there is a fault message on the energy storage system, switch off the application.
  • Only switch on the application again when you have identified and eliminated the cause of the fault.
  • Refer to the documentation of the MOVIKIT® software modules.

The devices are taken into operation using the MOVISUITE® engineering software from SEW‑EURODRIVE. The parameters that are required for the application are determined within the scope of project planning. These parameters must be set correctly in the MOVISUITE® engineering software.

Startup with MOVISUITE® can be performed intuitively.