Connection of main row and auxiliary row with DCP35A cable set and connection unit

• Use the screws [2] to screw the 3 conductor rails [1] to the insulator [3]. The tightening torque is 2.5 – 3 Nm.
• The DC link connections U_z+ and U_z- must be twisted 3 times, see the following figure.
• Use the screws [5] to screw the 3 prefabricated DC link connections [4] to the conductor rails [1]. The tightening torque is 3 – 4 Nm.

The steps described above must be performed at both insulators.

Mount the preinstalled insulators to the axis module as follows:

• Push the conductor rails [1] under the DC link bars [6] of the module and use the screws [7] to connect them.
• Re-install all covers.