Sync phase angle in °

Setting range: 0 – 360°

To have the currents of two supply units flowing in phase, you can set the phase angle of the line cable current of an MP slave to that of an MP master in synchronization mode. If the phase angle remains at the factory setting 0°, the phase angles are the same. This means nearly the full power is available at the junctions of the respective line cable systems.

The setting 180° reverses the current direction.

A phase shift of 180° is useful, if:

• The current direction is reversed at junctions due to unfavorable cabling.
• A re-cabling is to be prevented.

Runtime-related faults can be precisely adjusted with phase shifts that slightly vary from 0º or 180º. This, however, is usually not required.