Installation requirements

Check that the following conditions have been met:

  • The information on the drive unit's nameplate must match the voltage supply system.
  • The drive unit is undamaged (no damage caused by shipping or storage).
  • Ambient temperature according to the "Technical data" chapter in the product manual.
  • The drive unit must not be installed in the following ambient conditions:
    • Potentially explosive atmosphere
    • Oils
    • Acids
    • Gases
    • Vapors
    • Radiation
  • Clean the output shafts and flange surfaces thoroughly to ensure that they are free of anti-corrosion agents, contamination or similar. Use a commercially available solvent. Do not expose the sealing lips of the oil seals to the solvent – damage to the material.