Startup/operation

Observe the safety notes in chapters Startup and Operation in this documentation.

The products may have moving or rotating parts during operation. This can result in hazards due to crushing, squeezing, cutting, or getting pulled in.

Mechanical blocking or internal protective functions of the product can cause a motor standstill. Eliminating the cause of the problem or performing a reset may result in the drive re-starting automatically. If this is not permitted for the drive-controlled machine for safety reasons, first disconnect the product from the voltage supply and then start troubleshooting.

Never plug or unplug plug connectors, interface modules, or other electrical connections while they are live. This may result in dangerous electric arcs damaging the product.

The fact that the operation LED and other display elements are no longer illuminated does not indicate that the product has been disconnected from the voltage supply and no longer carries any voltage.

Risk of burns: The surface temperature of the product can exceed 60 °C during operation. Do not touch the product during operation. Let the product cool down before touching it.

Switching the voltage supply off and on again without sufficient cooling time can damage the device.

Observe the corresponding information signs on the product.