Operating mode "Outfeed"

Functional description
Mode selection	Mode 601
Requirement	The drive is enabled.
Description	At the positive edge of the start bit, the drive accelerates along the set acceleration ramp until it reaches rapid speed. Upon removing the start bit or the direction of rotation, the drive brakes along the deceleration ramp until it stops. Negative setpoint speeds are ignored. In unidirectional operating modes, the direction that is not configured is ignored, the inverter remains stopped in FCB 05, and no error message is issued.

Functional description

Mode selection

Mode 601

Requirement

The drive is enabled.

Description

At the positive edge of the start bit, the drive accelerates along the set acceleration ramp until it reaches rapid speed.

Upon removing the start bit or the direction of rotation, the drive brakes along the deceleration ramp until it stops.

Negative setpoint speeds are ignored. In unidirectional operating modes, the direction that is not configured is ignored, the inverter remains stopped in FCB 05, and no error message is issued.

MOVIKIT® RapidCreepPositioning Drive