Configuring process data manually

If you do not use a MOVIKIT® software module, you have to configure the process data source and the process data manually.

Proceed as follows:

  1. Open the configuration of the inverter and define the corresponding parameter settings under:
    • [Setpoints] > [Basic settings] (e.g. the process data source)
    • [Setpoints] > [Setpoint connection]
    • [Setpoints] – [Profile value connection]
    • [Setpoints] > [Control word 1]/[Control word 2]/[Control word 3]
    • [Actual values] > [PI data]
    • [Actual values] > [Status word 1]/[Status word 2]/[Status word 3]
  2. Save the MOVISUITE® project.