Software restart
A software restart is no real reset of the micro controller.
Response | Effect |
|---|---|
Software restart | The firmware will be restarted, without the boot loader becoming active (no display "b0"!). |
Reference positions of incremental encoder systems will be lost. | |
Any existing fieldbus interfaces are not affected. | |
The interface between options and firmware system is initialized again. A new boot synchronization to the fieldbus or control option takes place. | |
The active "fault message" is reset (digital output = 1, system status = 0). |
The ready signal is set again depending on the system state after the reset by the system state control.
