Using the control terminals X5 – X6

Note the following information for actuating the control terminal clamps:

Connect conductor
without pressing the activation
button.

Connect conductor
after pressing the activation button.

The following conductors can be installed directly (without tools) up to two cross section sizes below the nominal cross section:

  • Single-wire conductors
  • Flexible conductors with end sleeves

When connecting the following conductors, you must press the actuation button on top to open the clamping spring:

  • Untreated, flexible conductors
  • Conductors with small cross sections that cannot be plugged in directly

Removing the conductor.

First press the activation button.

Before removing the conductor, first press the activation button on top.