Error 108 MOVIKIT® – EncoderInterface
Error: 108.64 (6C40hex | 27712dec) Description: Configuration parameter missing | ||
|---|---|---|
|
| |
Cause | Measure | |
Failed to find a required parameter in the configuration file. | – Check the configuration of the individual operating modes. – In MOVISUITE® in the parameter setting of the controller under [Data management], download the data by clicking "Update configuration data". | |
Error: 108.65 (6C41hex | 27713dec) Description: No external variable linked | ||
|---|---|---|
|
| |
Cause | Measure | |
The link of an input variable, a SendObject or an external source to the MOVIKIT® encoder interface is missing. | Link input variable. | |
Error: 108.66 (6C42hex | 27714dec) Description: Value outside valid numerical range | ||
|---|---|---|
|
| |
Cause | Measure | |
The error can be caused as follows: – The multiplication of the number of decimal places and the value in IrSetValue is outside the valid range of values. – The denominator of the user units set for MOVIKIT® EncoderInterface is 0. | – Set decimal place or IrSetValue smaller. or – Set denominator of the user units > 0. | |
Error: 108.70 (6C46hex | 27718dec) Description: Interface to the persistent data not linked | ||
|---|---|---|
|
| |
Cause | Measure | |
Internal error | Contact SEW-EURODRIVE Service. | |
Error: 108.71 (6C47hex | 27719dec) Description: No external variable linked | ||
|---|---|---|
|
| |
Cause | Measure | |
The external source link is missing. | Link input variable. | |
Error: 108.72 (6C48hex | 27720dec) Description: Configuration data interface not linked | ||
|---|---|---|
|
| |
Cause | Measure | |
Internal error | Contact SEW-EURODRIVE Service. | |
Error: 108.73 (6C49hex | 27721dec) Description: Interface not linked | ||
|---|---|---|
|
| |
Cause | Measure | |
Internal error | Contact SEW-EURODRIVE Service. | |
Error: 108.74 (6C4Ahex | 27722dec) Description: Deviation from persistently stored value and current value | ||
|---|---|---|
|
| |
Cause | Measure | |
The input variable, SendObject or external source deviates too much from the stored value after the controller has started up. | Increase or switch off warning limit (= 0). | |
