Removing EG7., AG7.

  1. Proceed as follows, depending on the design:
    • With canopy: Remove the screws [707] to disassemble the canopy [657]. If required, counter using a hexagon wrench SW13 on the spacer bolt [706].
    • Without canopy: Remove the screws [22]/[34] to disassemble the safety cover [361] or the forced cooling fan [170].
  2. Loosen the screws of the connection cover [619] and remove it. Do not disconnect the encoder cable.
  3. Unscrew the retaining screws [232] of the torque arm.
  4. Loosen the screw [B] by 2 – 3 revolutions to pull off the encoder [220].