Setup variants in a control cabinet

If, due to space constraints, the modules of an axis system cannot be set up in one row, some of the modules must be installed in a second row. There are 3‑setup variants for the two-row setup, which are described below.

INFORMATION

Change of the degree of protection

In variant 1 and 2, the degree of protection is reduced to IP10 when the DCP34A cable set is connected.

In variant 1 and 2, the main row and auxiliary row must be connected as in variant 3 if the IP20 degree of protection is required.

For the two-row setup in a control cabinet, cable sets from SEW-EURODRIVE must be used, see chapter Cable sets and accessories.