TLIFT – Inserting intermediate blocks at contour corners / command ignored in SRL

Ignored in the SRL program because tangential control always executes intermediate blocks. Alignment always takes place in the contour corner.

If TLIFT is present in the G-code, the command can either be used without arguments, or exactly the "slave axis" parameter is expected during import. One of the address letters of the Cartesian axes (X, Y, Z, A, B, C) is permitted as the slave axis, but the specification is ignored in the SRL program.

INFORMATION: The behavior of tangential control always corresponds to a Siemens NC program with TLIFT. On the other hand, when executed with a Siemens control without programmed TLIFT, the alignment takes place only in the next path segment, i.e. without intermediate blocks being inserted at contour corners. The absence of TLIFT does not lead to a fault during import.