Fault 229 Process variable 2
Fault: 229.0 (E500hex | 58624dec) Description: Process variable 2 – value too high | ||
|---|---|---|
|
| |
Cause | Measure | |
The value of process variable 2 has exceeded the maximum permitted value. | Reduce the torque/load. | |
The value of process variable 2 has exceeded the maximum permitted value. | Observe the operating instructions of the connected sensor. | |
Fault: 229.1 (E501hex | 58625dec) Description: Process variable 2 – value high | ||
|---|---|---|
|
| |
Cause | Measure | |
The value of process variable 2 is close to the maximum permitted value. | Check process variable 2. | |
The value of process variable 2 is close to the maximum permitted value. | Contact SEW-EURODRIVE Service. | |
