Fault 230 Process variable 3
Fault: 230.0 (E600hex | 58880dec) Description: Process variable 3 – value too high | ||
|---|---|---|
|
| |
Cause | Measure | |
The value of process variable 3 has exceeded the maximum permitted value. | Reduce the torque/load. | |
The value of process variable 3 has exceeded the maximum permitted value. | Observe the operating instructions of the connected sensor. | |
Fault: 230.1 (E601hex | 58881dec) Description: Process variable 3 – value high | ||
|---|---|---|
|
| |
Cause | Measure | |
The value of process variable 3 is close to the maximum permitted value. | Check process variable 3. | |
The value of process variable 3 is close to the maximum permitted value. | Contact SEW-EURODRIVE Service. | |
