ECR-A.M. roller drive

ECR-A.M. roller drive
Conveyor roller with integrated brushless 24 V or 48 V motor Up to 65 W continuous power with an overload capacity of 200% High mechanical stability through planet carrier with support on both sides Integrated Hall-effect motor encoder for simple positioning tasks Electronic holding brake with position hold control for slopes or lifting applications Electronic nameplate for automatic startup Remote commutation electronics with energy management system Maximum system efficiency due to energy recovery during braking Dissipation of regenerative energy if no consumer is available. Low noise level < 50 dB (A) due to integrated damping elements (depending on the installation situation) Tube material: Galvanized steel or stainless steel Maximum roller length: 1500 mm (greater lengths available upon request) Motor connection: robust standard connector M8 (4 pins) with 1 m cable Optional mechanical holding brake (only for 24 V) with motor connection via 9-pin JST connector with 500 mm cable

Conveyor roller with integrated brushless 24 V or 48 V motor
Up to 65 W continuous power with an overload capacity of 200%
High mechanical stability through planet carrier with support on both sides
Integrated Hall-effect motor encoder for simple positioning tasks
Electronic holding brake with position hold control for slopes or lifting applications
Electronic nameplate for automatic startup
Remote commutation electronics with energy management system

Low noise level < 50 dB (A) due to integrated damping elements (depending on the installation situation)
Tube material: Galvanized steel or stainless steel
Maximum roller length: 1500 mm (greater lengths available upon request)
Motor connection: robust standard connector M8 (4 pins) with 1 m cable
Optional mechanical holding brake (only for 24 V) with motor connection via 9-pin JST connector with 500 mm cable

ECR Roller Drive, ECG Gearmotor, ECC Fieldbus Controller