Binary mode (hardware controlled)

In binary mode, you can control 2 drives via 24 V signals. The following control commands are available for each drive:

  • Enable/stop
  • Selection of direction of rotation

To activate binary mode, proceed as follows:

  1. Click on the [Advanced dialog] button in the main menu of ECShell.
  2. Open the "Connections" tab.
  3. Click the [Activate] button.
  4. Click the [Set All] button.
  • Binary mode is active.

[1]

[Activate binary mode] button

[2]

[Set All] button

Once binary mode is activated, the display in the ECShell main menu changes.