Additional-Code
Der Additional-Code beinhaltet die SEW-spezifischen Returncodes für fehlerhafte Parametrierung der Frequenzumrichter. Sie werden unter Error-Class 8 = Anderer Fehler an den Master zurückgesendet. Die folgende Tabelle zeigt alle möglichen Kodierungen für den Additional-Code.
MOVILINK® | |||
|---|---|---|---|
Additional Code | |||
Error Class | High | Low | Beschreibung |
0x05 | 00 | 0x00 | Unknown error |
0x01 | Illegal Service | ||
0x02 | No Response | ||
0x03 | Different Address | ||
0x04 | Different Type | ||
0x05 | Different Index | ||
0x06 | Different Service | ||
0x07 | Different Channel | ||
0x08 | Different Block | ||
0x09 | No Scope Data | ||
0x0A | Illegal Length | ||
0x0B | Illegal Address | ||
0x0C | Illegal Pointer | ||
0x0D | Not enough memory | ||
0x0E | System Error | ||
0x0F | Communication does not exist | ||
0x10 | Communication not initialized | ||
0x11 | Mouse conflict | ||
0x12 | Illegal Bus | ||
0x13 | FCS Error | ||
0x14 | PB Init | ||
0x15 | SBUS - Illegal Fragment Count | ||
0x16 | SBUS - Illegal Fragment Type | ||
0x17 | Access denied | ||
| Not used | ||
0x08 | 00 | 0x00 | No Error |
0x10 | Illegal Index | ||
0x11 | Not yet implemented | ||
0x12 | Read only | ||
0x13 | Parameter Blocking | ||
0x14 | Setup runs | ||
0x15 | Value too large | ||
0x16 | Value too small | ||
0x17 | Required Hardware does not exist | ||
0x18 | Internal Error | ||
0x19 | Access only via RS485 (via X13) | ||
0x1A | Access only via RS485 (via XT) | ||
0x1B | Parameter protected | ||
0x1C | "Controller inhibit" required | ||
0x1D | Value invalid | ||
0x1E | Setup started | ||
0x1F | Buffer overflow | ||
0x20 | "No Enable" required | ||
0x21 | End of File | ||
0x22 | Communication Order | ||
0x23 | "IPOS Stop" required | ||
0x24 | Autosetup | ||
0x25 | Encoder Nameplate Error | ||
0x29 | PLC State Error | ||
