Cabling for single-point parallel connection

The following figure shows the combination of two or three TES31A supply units in single-point parallel connection. The SP master is freely selectable.

The system bus is not shown in the following figure for the sake of clarity.

[1]

CAN terminating resistor

[2]

Digital inputs/outputs

[3]

Synchronization signal

[4]

CAN T-piece

[5]

Transmission path with TLS line cable

The individual installation steps are described below:

  1. Connecting the synchronization signal
  2. Connect digital inputs and outputs
  3. Connecting the system bus
Additional information