Status LED "SF" (SYS FAULT)/"L40"
The status LED "SF" or "L40" is present in the following controllers:
- MOVI-C® CONTROLLER UHX65A‑R (L40)
- MOVI-C® CONTROLLER UHX85A‑R (SF)
Status | Possible cause | Measure |
|---|---|---|
Off | Error-free operating state | – |
Red, flashes for 3 s Switch-on time: 500 ms Switch-off time: 500 ms | To localize the network stations visually, the flashing test has been activated in the configuration of the PROFINET controller. | – |
Red Permanently lit | Error in hardware or configuration (channel/system error) | Switch the device off and back on again. Check the configuration. If the fault occurs repeatedly, contact SEW-EURODRIVE Service. |
