Setting the module parameters

To set the parameters of a module, do the following:

  • The application is in online mode.
  • The application is in "Run" state.
  1. To open the properties of the OCE12C bus coupler, double-click the node "EtherCAT (X30)"/"SBUS_PLUS1 (EtherCAT MasterSEW)"/"OCE12C (SEW OCE12C)" in the parameter tree.
  2. On the "General" tab, in the "Additional" group, select the "Enable expert settings" check box.
    • The tabs "Process data expert mode", "Online" and "CoE Online" are displayed.
  3. Open the "CoE Online" tab.
  4. Set the parameters.