Information
Observe the following information:
- Use the supplied NOCO-Paste for mounting. This will prevent contact corrosion and simplify disassembly at a later date.
- The key dimension L12 is determined by the customer and depends on the requirements of the application, as well as on the used materials. See figure "Customer shaft with contact shoulder [A] and without contact shoulder [B]".
- When dimensioning the keyed connection, take into account that the hollow gear shaft (hub) is made of the material C45R(1.1201) or X17CrNi16-2+QT900(1.4057+QT900), depending on the ordered variant.