Software restart
A software restart does not actually reset the micro controller.
Response | Effect |
|---|---|
Software restart | The firmware is restarted without the boot loader becoming active (no display of "b0"!). |
Reference positions of incremental encoder systems are lost. | |
Any fieldbus interfaces that are present are not affected. | |
The interface between the options and the firmware system is re-initialized. A new boot synchronization to the fieldbus or control option takes place. | |
The active "fault message" is reset (digital output = 1, system status = 0) |
The ready signal is set again depending on the system state after the reset by the system state control.
