Replacing the electronics cover

The MOVI-C^® system offers the option to save the application-related data set for the inverter and the data set for the safety option on the memory module in the inverter or on the MOVI-C^® CONTROLLER. This step must be performed in advance by the user with the MOVI-C^® CONTROLLER.

To replace the electronics cover, you must perform the following steps:

1. Switch off the basic device to be replaced.
2. Open the screw fitting of the electronics cover. Remove the plugged-in memory module from the electronics cover.
3. Replace the electronics cover (including the MOVISAFE^® CS..A safety option).
4. Insert the memory module that was removed in step 2 into the new electronics cover. Mount the electronics cover.
5. Switch on the basic device again. Carry out a functional test. The checking of all parameters is omitted.

The replacement of the electronics cover is detected automatically and the application-related data set is loaded from the memory module into the MOVISAFE^® CS..A. The MOVISAFE^® CS..A safety option is subsequently in the same state that it was in before the replacement of the electronics cover. This means that the MOVISAFE^® CS..A safety option will be in the "Accepted" state again afterwards if it was in the "Accepted" state before the replacement of the electronics cover. A function test of the safety option is required after the replacement of the electronics cover.