Interface module replacement

Replace the interface module as follows:

  1. Observe the safety notes.
  2. Undo the screws and remove the interface module from the motor, see chapter "Rotating the interface module", section Removing the interface module.
  3. Compare the data on the nameplate of the previous interface module with the data on the nameplate of the new interface module.

    4. INFORMATION

    Always replace the interface module with an interface module with the same type designation.
  4. Place the new interface module on the motor and screw it tight.
  5. Supply the device with voltage.
  6. Check whether the new interface module is functioning properly.