Applying devices

After performing the network scan, a result list with all detected devices and subcomponents is displayed. This result list is used to select which devices and subcomponents are applied to the device list. To apply devices and subcomponents, proceed as follows:

  • A device scan has been performed and the result list contains entries.
  1. Use the choice boxes to select the devices and subcomponents to be applied. If you want to apply all displayed devices, you can skip this step and click the [Apply all] button. INFORMATION: If you select a subcomponent, the corresponding device is always also applied.
    • The result list can be filtered using the drop-down list at the top right. If "Prefer fieldbus route" is selected, all detected devices are displayed. If a device has a fieldbus route and an engineering route, the fieldbus route is applied automatically. If "Only fieldbus route" or "Only engineering route" is selected, only devices that were found via the corresponding route are listed.
  2. Click the [Apply selection button].
    • The selected devices and subcomponents are applied to the device list.