Installing the shield plate for the power section
A set of shield terminals is supplied as standard for the power section sizes 1 – 4. The shield terminals for the power section provide you with a way of installing the shield for the motor, brake and braking resistor cables. The shield terminals are not yet installed on the unit. Install the shield terminal on the power section together with the unit's retaining screws. Insert the shield terminal as follows:
- Sizes 1 – 2
- Sizes 3 – 4
- Sizes 5 – 8
- No shield terminals for the power section are supplied with these sizes. Use commercially available shield terminals to install the shielding of the motor, brake and braking resistor cables. Apply the shielding as closely as possible to the inverter.
