Absolute positioning

Parameter name

Value

Absolute positioning

Without referenced encoder
  • Yes – Allow positioning if the inverter has not yet been referenced.
  • No – Do not allow positioning if the inverter has not yet been referenced.

Index: 50003.1

IEC name: ProfileGeneration.Positioning.Config.xWithoutReferencedEncoder

Target position monitoring
  • On – Check whether the target position is within the set software limit switches. If the target position is outside the set software limit switches, the motion is not started and a fault is displayed.
  • Off – Do not check if the target position is within the set software limit switches.

Index: 50003.2

IEC name: ProfileGeneration.Positioning.Config.xTargetPositionMonitoring