Replacing the drive unit

Replace the drive unit as follows:

  1. Observe the safety notes.
  2. Remove the drive unit. Pay attention to the Disassembly instructions in chapter "mechanical installation" when doing this.
  3. Compare the data on the nameplates of the old drive unit with the data on the nameplates of the new drive unit.

    4. INFORMATION

    Always replace the drive unit with a drive unit that has the same properties.
    In safety-related applications, replace a drive unit only with a drive unit with the same FS logo.
  4. Mount the drive unit. Observe chapter Mechanical installation.
  5. Perform the installation according to chapter Electrical installation.
  6. Set all control elements (e.g. DIP switches, see chapter Startup) on the new electronics cover in the same way as the controls of the previous electronics cover.
  7. Remove the memory module from the old electronics cover. Insert this memory module in the new electronics cover.
  8. Place the electronics cover onto the connection box and screw it on.
  9. Supply the drive with voltage.
  10. Check the new drive unit for proper functioning.