Disassembly notes

INFORMATION

Information regarding the SEW-EURODRIVE assembly/disassembly kit can be found in the product manual > chapter Design notes for gear units with hollow shaft and key.

The following description only applies when the drive is assembled using the SEW-EURODRIVE assembly/disassembly kit (see previous description, points 2B or 2C).

  1. Perform the steps according to chapter Installation notes.
  2. WARNING! Risk of burns due to hot surfaces. Severe injury. Let the devices cool down sufficiently before touching them.
  3. Loosen the retaining screw [1].
  4. Remove parts [2] to [4] and, if present, the spacer tube [5].

    5. [1]

    Retaining screw

    [2]

    Lock washer

    [3]

    Washer

    [4]

    Retaining ring

    [5]

    Spacer tube

    [6]

    Customer shaft

  5. Insert the forcing washer [8] and the fixed nut [7] from the SEW-EURODRIVE assembly/disassembly kit between the customer shaft [6] and the retaining ring [4].
  6. Re-insert the retaining ring [4].
  7. Screw in the retaining screw [1] again. You can now force the drive from the shaft by tightening the screw.

    8. [1]

    Retaining screw

    [4]

    Retaining ring

    [6]

    Customer shaft

    [7]

    Fixed nut

    [8]

    Forcing washer