Disassembly notes

INFORMATION

For information on the SEW-EURODRIVE assembly/disassembly kit, see chapter Design notes for gear units with hollow shaft and key.

The following description only applies when the drive is assembled using the SEW‑EURODRIVE assembly/disassembly kit (see previous description, points 2B or 2C).

  1. Perform the steps according to chapter Installation notes.
  2. WARNING! Risk of burns due to hot surfaces. Severe injuries. Allow the devices to cool down before touching them.
  3. Loosen the retaining screw [1].
  4. Remove parts [2] to [4] and, if applicable, the spacer tube [5].

    5. [1]

    Retaining screw

    [2]

    Lock washer

    [3]

    Washer

    [4]

    Retaining ring

    [5]

    Spacer tube

    [6]

    Customer shaft

  5. Insert the forcing washer [8] and the fixed nut [7] from the SEW‑EURODRIVE assembly/disassembly kit between the customer shaft [6] and the retaining ring [4].
  6. Re-install the retaining ring [4].
  7. Screw the retaining screw [1] back in. Now you can force the drive off the shaft by tightening the screw.

    8. [1]

    Retaining screw

    [4]

    Retaining ring

    [6]

    Customer shaft

    [7]

    Fixed nut

    [8]

    Forcing washer