Configuration

[1]

Change configuration/apply configuration

[2]

Module configuration: The options on the page change depending on whether "Mode" or "Mapping" is selected.

[3]

Available and configurable fixed setpoints in "Mode" and "Mapping"

[4]

Fixed setpoint travel parameters: You can click the button to apply the values for the entire table.

[5]

Assignment of the digital input to sensor M1 or sensor M2 and configuration of the sensor logic (NC contact/NO contact); FOR MODE 3: INTERLOCK, fixed assignment of the sensors to the direction of rotation, the digital inputs are to be assigned to the wiring accordingly. Sensor M1, direction of rotation right; sensor M2, direction of rotation left