Process data configuration

The inverter is controlled via the process data channel. Process data words are mapped in the I/O or peripheral area of the PLC (PROFIBUS master) and can be addressed as usual.

The following table shows the assignments of the PROFIBUS slot model on the inverter:

Slot

Process data module

1

Reserved

2

Module I/O (05 words)
for the MOVIKIT® Velocity Drive software module

Module I/O (08 words)
for the MOVIKIT® Positioning Drive software module

Module I/O 01 – 16 (number of process data words according to the configuration of the device)

3 – 5

Can be assigned in the same way as slot 2.

INFORMATION

A maximum of 16 process data words may be assigned to the slots of the slot model.