Hardware
The following hardware is required:
- MOVI-C® CONTROLLERS of the following performance class:
- All MOVI-C® CONTROLLERS can be employed to use MOVIKIT® StackerCrane effiDRIVE with MOVIKIT® StackerCrane MultiMotion. Note that a maximum of 3 axes may be operated when using the MOVI-C® CONTROLLER type UHX15A.
- At least one MOVI-C® CONTROLLER type UHX45A is required to use MOVIKIT® StackerCrane effiDRIVE with MOVIKIT® StackerCrane MultiAxisController. Make sure that all drives of a MultiAxisController axis group have the same drive train. Otherwise, contact SEW‑EURODRIVE.
- Also note the Cycle times to be set in each case.
- Inverter as an interpolating device
For information on compatibility of the inverters used, refer to the MOVI-C® software modules document.
