Setting up the fieldbus connection
Perform the following steps to give the MOVI-C® CONTROLLER access to the fieldbus via IEC function blocks. These settings are required for direct fieldbus connection of software modules.
- A MOVISUITE® project has been created and is open.
- The MOVISUITE® project includes a MOVI-C® CONTROLLER.
- Open the configuration of the MOVI-C® CONTROLLER.
- In the "MOVIRUN® flexible" section, open the "Module configuration" > "Fieldbus interface" configuration menu.
- Select the fieldbus protocol in use in the "Fieldbus card" section.
- The fieldbus connection has been set up successfully. For more information, refer to chapter Process data assignment. Use the tool MOVIRUN® DiagnosticMonitoring to monitor and control the fieldbus interface.
