Sizes X100 – 160
- Loosen the retaining screw [6]. Remove the outer retaining ring [8] and pull off the end plate [4].
- To protect the centering bore, screw the retaining screw [6] into the machine shaft [1].
- Turn the end plate [4] and reinstall the end plate [4] and the outer retaining ring [8].
- Thread the ejector screw [9] into the end plate [4] to remove the gear unit from the machine shaft [1]. Disassembly is easier if you first apply lubricant to the ejector screw [9] and the thread in the end plate [4].
[4] | End plate |
[6] | Retaining screw |
[8] | Retaining ring |
[1] | Machine shaft |
[6] | Retaining screw |
[4] | End plate |
[8] | Retaining ring |
[1] | Machine shaft |
[4] | End plate |
[9] | Ejector screw |
