Cleaning and lubricating the shrink disk

Before reassembly, clean and lubricate the shrink disk.

Perform the following steps carefully to ensure proper functioning of the shrink disk. Use only products that are comparable to the specified lubricant.

INFORMATION

  • If the tapered surfaces of the shrink disk are damaged, the shrink disk can no longer be used. Replace the shrink disk.

[6a]

Locking screws

[6b]

Taper (outer ring)

  1. Thoroughly clean the removed shrink disk from dirt and the remaining adhering lubricants.
  2. Apply an MoS2 compound onto the threads and under the screw heads of the locking screws [6a], for example "gleitmo 100" from FUCHS LUBRITECH (www.fuchs-lubritech.com).
  3. Also evenly lubricate the tapered surface of the taper (outer ring) [6b] with a thin layer of an MoS2 compound.