Version overview

Version

Change

3.2.0.200

MOVISUITE® V2.10

First series version. For detailed information on the functions included, refer to the respective MOVISUITE® manual.

INFORMATION: Due to the implementation of the "Runtime slicing" data flexibility function, this version can only be run as of firmware 6.0.

6.0.0.200

MOVISUITE® V2.20

Error eliminations:

The digital outputs are reset in the event of a fieldbus timeout.

6.1.0.200

MOVISUITE® Module Update Package V2.20

Error eliminations:

With MOVITRAC® advanced, you can now switch to drive train 2.

6.2.2.200

MOVISUITE® V2.30

New functions:

  • Jerk limitation via PO 9 (optional)
  • Free assignment of sensor inputs (optional)
  • Installation of an additional logic link when using an additional "In position" sensor

Error eliminations:

  • Visibility of the DIOs with MOVITRAC® advanced in PI 5
  • Revisions in the interface
  • Behavior of "Drive train 2 active" status bit with remote devices

10.0.9.200

MOVISUITE® Data Update V2.31.2

New functions:

  • MOVIKIT®-specific errors are displayed as subcomponent errors in the error message of the inverter. This allows fieldbus alarm messages, such as PROFINET alarm messages, to be triggered.
  • Support of MOVIPRO® technology MPX..
  • Support for compact extra-low voltage drives MOVIMOT® performance ELV

Error eliminations:

The "Show drive train 2" parameter is also displayed in the configuration of the software module under [Basic settings] for MOVITRAC® advanced.

10.2.1.200

MOVISUITE® V2.60

New functions:

  • Startup of the software module using the "Startup wizard" tool
  • Changes in the parameter tree
  • Adjusting the help texts of the parameters

New devices:

  • MOVITRAC® classic via gateway
  • MOVITRAC® basic via gateway