General information
DANGER
Dangerous voltages present at cables and motor terminals.
Severe or fatal injuries from electric shock.
- Dangerous voltages are present at the output terminals and the cables and motor terminals connected to them when the device is switched on. This also applies even when the device is inhibited and the motor is at standstill.
- Check whether the device is disconnected from the power supply before you start working on the power connections.
- After disconnection from the power supply, wait at least 10 minutes and ensure that there is no voltage present before you start working on the power connections.
- The fact that the operation LEDs are no longer illuminated does not indicate that the application inverter no longer carries any voltage.
- Observe the general safety notes in chapter Safety notes.
DANGER
Risk of crushing if the motor starts up unintentionally.
Severe or fatal injuries.
- Ensure that the motor cannot start inadvertently, for example, by removing the electronics terminal block X20.
- Additional safety precautions must be taken, depending on the application, to avoid injury to personnel and damage to machinery.
NOTICE
Switching the motor output at the application inverter with enabled output stage.
Damage to the application inverter.
- The motor output of the application inverter may be switched or disconnected only when the output stage is inhibited.
