Vibration monitoring system /DUV40A

The DUV40A vibration monitoring system is used to detect damage of gear units and gearmotors at an early stage (e.g. bearing damage or imbalances). Permanent broadband frequency-selective monitoring of the gearmotor is used for this purpose. Apart from the vibration analysis, additional measured values of up to 3 signal encoders can be detected, recorded, and analyzed. The additional signals can be used as reference values for signal analysis e.g. to trigger event-based measuring tasks. After the analysis and, depending on alarm limits defined during rated operation of the drive (teach-in mode), the system can switch outputs and display the alarm state using LEDs.

The SmartWeb software is used to configure and visualize the DUV40A system. If you use several DUV40A systems, you can control them via the SmartUtility Light software centrally from one PC (this software is included in the scope of delivery).

If you purchase the full version of the SmartUtility, you can analyze measurement data in the SmartUtility Viewer and download configurations or upload them onto other devices.

For further information, refer to chapter Information on the vibration monitoring system /DUV40A.