Extension of the motor connection cable

Both ECR and ECG drives have a factory-installed connection cable of 1 m of length. The drives have an M8 socket (female) that is compatible with the motor connections of the ECC-DFC fieldbus controller. It is possible to extend the motor cable. The extension cable must meet the following requirements:

Designation

Requirement

A-side

M8, A-coded, male, 4-pin

B-side

M8, A-coded, female, 4-pin

Temperature range

-30 °C – +80 °C

Minimal cross section

0.32 mm2 (AWG 22)

Maximum total lengthincl. plug connector, observe derating

4 m