Drive unit

The following table shows the inspection intervals for the motor:

Time interval

Activity

Design

Every 2500 operating hours, or annually

Check for possible bearing damage in the event of running noise.

In the event of bearing damage, have the bearing replaced by SEW-EURODRIVE Service or specialists trained by SEW-EURODRIVE.

  • Specialists at customer site
  • Qualified specialists trained by SEW-EURODRIVE
  • SEW-EURODRIVE Service

Regularly

Visually check the cables for damage.

If required, replace the cables.

  • Specialists at customer site
  • Qualified specialists trained by SEW-EURODRIVE
  • SEW-EURODRIVE Service

Every 10 rotation cycles of the plug connector

Check plug connector for damage.

If damage is found, contact SEW-EURODRIVE Service.

  • Specialists at customer site

Every 500 mating cycles of the plug connector

Check the connections on the motor for damage.

If damage is found, contact SEW-EURODRIVE Service.

  • Specialists at customer site

Every 5 million cable bending cycles

Replace cables.

  • Specialists at customer site