Work steps with electronics cover size 1

NOTICE

Loss of the guaranteed degree of protection.
Damage to property.
  • When the cover is removed from the connection box, the cover and the wiring space must be protected from humidity, dust or foreign particles.

Replace the gasket of MOVIMOT® flexible as follows:

  1. Perform the steps according to chapter Preliminary work regarding inspection and maintenance.
  2. Loosen the screws of the electronics cover and remove it.
  3. NOTICE! Loss of the guaranteed degree of protection. Possible damage to property. Make sure that the sealing surfaces are not damaged when removing the gasket. Loosen the used seal by levering it off the retaining cams.
    • Disassembly is easier if you adhere to the sequence shown in the following figure.
  4. Remove the old gasket completely from the connection box.
  5. CAUTION! Risk of injury due to sharp edges. Cutting injuries. Use protective gloves when cleaning. Ensure that work is carried out by trained specialists only. Carefully clean the sealing surfaces of the connection box and the electronics cover.
  6. Place the new gasket on the connection box and fix it with the retaining cams. Installation is facilitated if you follow the illustrated order.
  7. Check the installation and startup of the device using the applicable operating instructions.
  8. Place the electronics cover back onto the connection box and secure it.
    • Proceed as follows when mounting the electronics cover: Insert/screw in the screws and tighten them in diametrically opposite sequence step by step with a tightening torque of 6.0 Nm.