Installing the device from the front

  • Required fasteners: 2 × short M4 screws, 4 × long M4 screws (included in the scope of delivery)

    [1]

    Mounting surface

    [2]

    Short M4 screws (2 ×)

    [3]

    Long M4 screws (4 ×)

  1. Use a thermally conductive pad, graphite foil or thermal paste between the device and the mounting plate.
  2. Place the device flat on the mounting surface.
  3. Attach the device to the mounting surface using M4 screws. For the bore dimensions, refer to chapter Technical data.
  4. Tighten the M4 screws with a tightening torque of 3 to 3.4 Nm.
Additional information