Replacing the memory module

Replace the memory module as follows:

  1. Observe the safety notes.
  2. Loosen the screws and take off the electronics cover from the connection box.
  3. Remove the memory module from the old electronics cover.
  4. Compare the part number and the status of the memory module.

    5. INFORMATION

    The new memory module must have the same part number and the same (or a higher) status as the old memory module.
  5. Set the DIP switches on the new memory module in the same way as the control elements of the previous memory module.
  6. Insert the new memory module in the new electronics cover.
  7. Place the electronics cover onto the connection box and screw it on.
  8. Supply the device with voltage.
  9. Check the startup of the device.
    • If required, perform startup again or load the saved startup to the device.
    • For devices with safety card, check the startup of the safety card. For more information, refer to the "MOVISAFE® CSB51A Safety Option" manual.
  10. Check the new electronics cover for proper functioning.