Startup requirements

NOTICE

Gear unit overload.
Damage to the gear unit.
  • Observe the peak torque of the gear unit when you configure the current limit and torque limit.
  • Check the current limits and torque limits and adjust them, if necessary.

Startup is only required when you need to change the factory set parameterization.

In this case, the following conditions apply to startup:

  • You have installed the device correctly both mechanically and electrically.
  • You have performed a correct project planning for the device.
  • Safety measures prevent accidental startup of devices.
  • Safety measures prevent danger to persons or machines.

Required hardware components:

  • PC or laptop according to product manual > chapter "PC connection"
  • Interface cable and, if applicable, interface adapter according to product manual > chapter "PC connection"

Required software:

  • Engineering software MOVISUITE® standard by SEW-EURODRIVE.