Cycle times

The cycle times listed as follows will result depending on which hardware and software components are used. These cycle times must be set on the MOVI‑C® CONTROLLER and/or on the inverters. For information on how to set the cycle time, refer to chapter Setting the cycle time.

 

The following specifications apply with regard to the software used:

  • When using the MOVIKIT® StackerCrane MultiAxisController, set the cycle time on the MOVI-C® CONTROLLER and the inverters to ≤ 2 ms.
  • When using the MOVIKIT® add-on AntiSway, set the cycle time on the MOVI-C® CONTROLLER and inverters to < 2 ms (use at least one MOVI-C® CONTROLLER UHX65A-R02).

 

If you want to use other cycle times, contact SEW‑EURODRIVE Service.