Inverter settings

[1]

Start measurement of load inertia

[2]

Currently measured load inertia in kg*cm²

[3]

Measured mean value of load inertia in kg*cm²
In control mode, this can also be specified manually.

[4]

Deviation of currently measured mean value from previous measured value in %

[5]

Transmit mean value of the load inertia to all inverters

INFORMATION: In non-expert mode, the parameters of the speed controller are also adapted to the changed load inertia. To do so in expert mode, click [Transmit speed controller values to inverter].

[6]

Currently set (active) load inertia in kg*cm²

[7]

Stiffness (entered via edit box or slider)
INFORMATION: A change to this value is automatically transferred to all the inverters

[8]

Zero clearance (entered via edit box or slider)
INFORMATION: A change to this value is automatically transferred to all the inverters

[9]

Suggested values determined on the basis of "Zero clearance" and "Stiffness"
(only visible in "expert mode")

[10]

Accept suggested values
Requirement: "Advanced settings" [13] active
(only visible in "expert mode")

[11]

Current effective setting values
Requirement for manual adjustment: "Advanced settings" [13] active (only visible in "Expert mode")

[12]

Transmit the setting values of the control to all inverters (only visible in "Expert mode")

[13]

"Advanced settings" for inhibiting the input of "Stiffness"/"Zero clearance" and for enabling manual adjustment of the controller values independently of each other (only visible in "Expert mode").