M23 connector
The M23 connectors are available in the following variants:
- [1] "Straight" connector
- [2] "Angled" connector
After plugging in the mating connector, you can align the angled connector without the need for additional tools.
Observe the following notes:
- Adjust the connector only when installing and connecting the drive unit.
- Do not use pliers to adjust the right-angle connector.
- Turn the right-angle connector only with plugged-in mating connector.
- The gap between the connector and the socket is approx. 2 mm.
- Tighten the union nut of the M23 connector to 3 Nm.
- Make sure that the connector does not move permanently.
Additional information
